Supreme Wiring A 240 Breaker

Running a wire from a new breaker in the breaker panel to a workshop area in the basement for a 240 volt circuit for my table saw and bandsaw http woodgear.

Wiring a 240 breaker. Strip the end of the wire and secure it in the same fashion as the ground wire. Thread the ground wire through the ground bar and run the wire to the end of the 240 volt receptacle in the breaker box. Run a normal or neutral wire over a normal wire bus strip.

Connect the hot wires to your 240v double pole breaker. Connected to this screw should be a red black or blue covered wire. On each half of the breaker there will be a terminal for connecting the end of one of the hot wires and a screw to secure it.

A dedicated 20 amp circuit like this is used for heavy household appliances like large portable window air conditioners. Take the cover of the breaker box off. Connect the red wire to the left terminal on the line in side of the gfci.

This switch doesn t use a neutral conductor. Strip the ends of the red and black wires and insert each one into one of the. For one thing both supply wires for this switch carry voltage.

A 240 volt 3 wire receptacle has three prongs two hot and one ground to accept a 3 prong plug. A typical 240 volt 30 amp circuit includes a double pole circuit breaker which has two terminals for the two hot wires. A neutral wire is not used in this circuit.

This should be located at the top of the breaker panel. This strip will be located just like the ground bar with many other neutral wires attached to the side. Screw the ground wire to the end of the 240 volt receptacle.